Reduce power consumption in the refrigerator: a flashlight is enough
Refrigerators use electricity 24 hours a day. But especially with devices that are always in use, the power consumption should be kept as low as possible. A little trick can be used to check whether the refrigerator is actually wasting energy. Even a flashlight is sufficient for this.
Fridges and freezers can prove to be real power guzzlers. Older devices in particular consume a lot of energy, especially since they run 24 hours a day. It is all the more important to investigate possible energy wastage, which many consumers do not even think about. In times of skyrocketing electricity costs every refrigerator owner should take a momentto use a simple trick. All you need is a flashlight.
Easily track down refrigerator power wastage
In particular in older refrigerators and freezers Is it worth picking up a flashlight (Source: Count seals). This is switched on and then placed in the device. Then all you have to do is close the door. Especially in the evening or at night when it is dark, the refrigerator should be looked at from the outside.
If no light from the flashlight can be seen from the outside, then everything is fine. The seals of the device do not need to be replaced. It looks different again when light is recognizable. That means that warm outside air entering the refrigerator. The device therefore has to use more energy to keep food and drinks cool inside. Significantly more condensation is also formed, which can also be interpreted as a sign of a leaking refrigerator door.
Everything about the energy labels for household appliances in the video:
How to replace the fridge seal
A fridge seal can relatively easy to replace yourself be, expert knowledge is not required. When purchasing, it helps to have the brand and unit number of the refrigerator at hand. Seals can be ordered online or purchased from specialist retailers.
Once the new seal is ready, the refrigerator should first be emptied and defrosted. The old seal is in many cases only infected or attached to the door with small screws. So it’s pretty easy to remove, sometimes not even a screwdriver is needed.
For most refrigerators, the new gasket will be easy pressed into the gap provided. This is easier if you start in one of the corners and then wrap the gasket around the fridge door.
if the Seal too long should be, it can be cut to fit with a carpet knife. To avoid possible gaps, an excess of a few millimeters should be left on all sides. Finally, if necessary, the previously loosened screws are attached.
